Using a new drywall compound fill in this area on the wall. Also, cover the area where the tape was removed. Put a strip of fiberglass over the seam while the mixture is still wet. This will close the gaps. Be sure to smooth out any wrinkles.
Once the mixture is dry add another thin coat. Cover the edges and blend it into the wall. Thinner layers should be used because thick layers may lead to additional cracking.
When this layer is dried smooth it out. Use a joint compound taping knife to apply a third coat to this area. Try to blend and smooth the coats, so they are not noticeable. After this coat dries be sure to sand it.
Nail Pops
It is not uncommon for the nail head and studs to stick out of the drywall. This can be caused by the warping of wood once the installation process is complete. While this is not dangerous is it not appealing to look at.
Using a utility knife be sure to remove the drywall where the nail is sticking out.
To fix the nail use a hammer to drive it back into the wall. A person can then use a bracket to secure each nail. The nail can also be removed, and a screw can be put in its place.
Be careful when using drywall screws. The head may “create a dimple on the surface of the wall.” says Don Frye, a gypsum board lower mainland British Columbia installer. The screw can be covered with a joint compound. When there are multiple screws used in a row use a spot patch for each and then cover them with fiberglass. To make them blend in use the steps mentioned above.
Corner Bead
Drywalls usually have metal or plastic edges for reinforcement. They are referred to as corner beads. While these beads are damage resistant the drywall that covers it may become chipped or break off. This damage can usually be replaced without a problem.
If the damage is done to the compound remove the loose drywall material and apply new materials. No tape is needed.
If the bean has become dented a metal cutting hack saw can be used to cut the bead and to remove any of the area that has been damaged. A utility knife can be used to do this. The beads may be attached to the drywall nails so a claw hammer may be needed to remove any fasteners. A taping knife may be used if there is plywood to prevent additional damage to the wall. Be careful when working with drywall that is unsupported. Be sure not to make a hole that will require additional repairs to the drywall.
A pair of metal snips can be used to cut a section out where the new bead is going to be placed. Apply joint compound in the corner and add the beads. Add an additional layer of compound over this bead. Allow it try dry and then add an additional layer of compound if it is needed.
Special thanks to Kevin for writing this article. You can find more from here at:
Drywall Vancouver
82 E 37th Ave, Vancouver, BC V5W 1E2
(604) 229-3691
